What should be paid attention to during the maintenance of the mold incubator

Mold incubator is mainly used to culture organisms and plants, set the corresponding temperature and humidity in a closed space, so that mold grows out in about 4-6 hours, as an artificial speed up the propagation of mold, check the anti-mold ability and mildew degree of electrical and electronic products. It is an important testing means in the artificial three climate, which is used by colleges and universities, medicine, military, electronics, chemical, biological scientific research departments for storage strains, biological culture, and necessary testing equipment for scientific research laboratories to test and judge its parameters and performance after the change of humid and hot temperature environment.

What should we pay attention to during maintenance?

1, if the incubator is not used for a long time, please empty the water in the box.

2. If the humidifier is faulty, please repair it according to the warranty point on the humidifier instruction manual.

3, handling must be careful, handling and horizontal Angle shall not be less than 45°.

4. When the use temperature is low, the water in the water tray at the bottom of the box should be dumped regularly.

5, when the temperature is set, you can not arbitrarily rotate the temperature control knob back and forth many times, so as to avoid frequent startup of the compressor, resulting in compressor overload phenomenon, affecting the service life of the compressor.

6, the bottom adjustment screw to adjust the height, so that the box is placed smoothly.