- Laminar flow cabinet
-
Biological safety cabinet
-
Fume hood
-
Pass box
-
air shower
- Autoclave/Steam sterilizer
- Incubator
-
Drying Oven
-
Clean sampling vehicle
-
Medical hand washing sink
-
Weighing booth
-
Particle counter
-
Air sampler
-
Muffle furnace
-
water distiller
-
ozone generator
-
water bath
-
Air purifier
-
vacuum pump
-
Colony counter
-
microcentrifuge
-
Pen PH meter
-
Vortex mixer
-
Anemometer
-
others
-
Glass bead sterilizer
The following points should be noted when using a biochemical incubator for a long service life
The following points should be noted when using a biochemical incubator for a long service life
1. Before opening the biochemical incubator, it is necessary to thoroughly familiarize oneself with the user manual and master the correct usage method. To maintain the service life of the biochemical incubator.
2. Biochemical incubator should be placed in a place with low dust and small temperature changes. The box must be grounded, using a three pin plug, and the socket should be properly grounded.
3. The inside and outside of the biochemical incubator should be kept clean daily, and should be cleaned after each use. If not in use for a long time, plastic dust covers should be covered and placed in a dry room. At the same time, the inner walls of the box and the surface of the equipment should be regularly wiped to maintain cleanliness and increase the transparency of the glass. Do not use acid, alkali, or other corrosive solutions to wipe the outer surface
4. During work, frequent opening of doors should be avoided to maintain temperature stability and prevent dust and dirt from entering.
5. Stop using the biochemical incubator, turn off the main power button, and turn off the power switch at the back of the equipment.
6. To ensure effective heat dissipation of the condenser, the distance between the condenser and the wall should be greater than 100mm. There should be a 50mm gap on the side of the box, and at least 300mm space on the top of the box.
7. It is strictly prohibited to contain volatile chemical solvents, explosive gases, and flammable gases in the box; Combustible sprays shall not be used near the biochemical incubator to avoid spark ignition.
8. After the training is completed, please pay attention to power off in a timely manner, and take out items in a timely and proper manner.