How to use the pass box

1. Wipe the object to be delivered with 0.5% peracetic acid or 5% iodophor.







2. Open the side door of the delivery window, quickly place the items to be delivered, use 0.5% peracetic acid spray to disinfect the delivery window, and close the side door of the delivery window.







3. Turn on the UV lamp in the transfer window, and uv irradiation will be required for at least 15 minutes.







4. Notify the experimenter or staff in the barrier system, open the inside side door of the transfer window, and take out the items.







5. Close the inside side door of the transfer window. , mainly used for the transfer of small items between the clean area and the clean area or between the clean area and the non-clean area, in order to reduce the number of clean room opening, reduce the pollution to the clean area to a low Z level.







The following is a brief introduction to the operation of the air shower transfer window, as follows:







Materials entering and leaving the clean area must be strictly separated from the flow passage, and shall be entered and left by the special passage for materials in the production workshop.







2. When the materials enter, the raw and auxiliary materials shall be sent to the temporary storage room of the raw and auxiliary materials through the transfer window after the person in charge of the preparation team organizes the personnel to remove the package or clean the surface. After removing the outer packing from the outer temporary storage room, the inner packing material is sent into the inner compartment through the transfer window. The general staff of the workshop and the person in charge of the preparation and internal packaging process handle the material handover.







3 when passing through the transmission window, the door inside and outside the transmission window must be strictly executed "one opens one closes" the regulation, two doors cannot open at the same time. After the material is put into the outer door, close the door first, then open the inner door to take out the material, close the door, and so on.







When the material is sent out from the clean area, the material should be first transported to the relevant material intermediate station and then removed from the clean area according to the reverse procedure when the material entered.







All semi-finished products shall be transported from the clean area to the external temporary storage room through the transfer window, and then transferred to the outer packing room through the logistics channel.







Materials and wastes that are very likely to cause pollution should be transported to the non-clean area from their special transfer Windows.







7. After the material entering and leaving, the site and transfer window of each compartment or intermediate station should be cleaned in a timely manner, and the internal and external access doors of the transfer window should be closed to do the cleaning and disinfection work.







We need to pay attention to the following specifications when operating the air shower transfer window:







1. Wipe the object to be delivered with 0.5% peracetic acid or 5% iodophor.







2. Open the side door of the delivery window, quickly place the items to be delivered, use 0.5% peracetic acid spray to disinfect the delivery window, and close the side door of the delivery window.







3. Turn on the UV lamp in the transfer window, and uv irradiation will be required for at least 15 minutes.







4. Notify the experimenter or staff in the barrier system, open the inside side door of the transfer window, and take out the items.







5. Close the inside side door of the transfer window.